Silicon image SiI3112/Sil3512 RAID 1.0.0.5 driver - is a Other drivers driver from . It runs on following
operating system: Windows 9X/ME/NT/2K/XP/2003/Vista/XP X64/2008. We recommend always using the most recent driver version available, so check for Silicon image SiI3112/Sil3512 RAID 1.0.0.5 driver new verison
on our site as often as possible.
Do not forget to set a system restore point before installing Silicon image SiI3112/Sil3512 RAID 1.0.0.5 driver - driver, to avoid problems that may occurs when you install a
wrong driver, or for other OS version etc. If a problem occur than you may restore you computer to previous time, before installing the driver.
Publisher review: This PCI Host Adapter can upgrade your desktop computer to have dual Serial ATA Channels. It can support both low profile and standard PCI interfaces. The board provides a 32 bit, 33/66 MHz PCI interface on the host side and dual, fully compliant Serial ATA ports on the device side to access Serial ATA storage media such as hard disk drives, floppy disk drives, CD-ROM, CD-RW, DVD-ROM.Features: Breaks Capacity-Limit to Support HDD larger than 137GB Dual high speed Serial ATA interface ports, each supporting 1st generation Serial ATA data rates 1.5Gb/s Fully compliant with Serial ATA 1.0 specifications Provides RAID 0 (Stripping) to greatly increase the performance of data transfer by simultaneously writing data to 2 drives Provides RAID 1 (Mirroring) to protect the data from a disk failure by writing identical data on 2 drives Supports Spread Spectrum in receiver Independent 256-byte FIFOs (32 bit * 64 deep) per Serial ATA channel for host reads and writes Compliant with PCI Specification, revision 2.2 Integrated PCI DMA engines 32 bit, 33/66MHz fully compliant PCI host interface Specifications:Compliant with Serial ATA Specification REV 1.0 Support Serial ATA data transfer rates up to 150MB/sec Support RAID 0 & RAID 1 Features independent 2560buty FIFOs per channel for host reads and writes Breaks the 137GB barrier! Supports various brands of large capacity serial ATA hard disk drives Flexible serial ATA cable is easier to route inside a PC SATA power cable: Connect the S-ATA hard drive and system power supply Silicon Image SiI3112 SATALink PCI Host Controller Compliant with Serial ATA specification Rev. 1.0 Slot type: 32-bit PCI Provides two independent channels to connect up to two serial ATA hard disk drives Support Serial ATA data transfer rates up to 1.5Gbps
Operating system:Windows 9X/ME/NT/2K/XP/2003/Vista/XP X64/2008
Related drivers:View related drivers
Silicon image SiI3112/Sil3512 RAID 1.0.0.5 driver - details 
Before you Download
